Sector Sieben - Berliner Platine Bp20
€75.00
Net: €63.03
In stock
The bus board Berliner Platine bp20 manufactured in Germany was developed especially for the requirements of modular systems
The Berlin circuit board bp20, consisting of 2 layers, convinces with large +12V and -12V main conductors, tapping lines for each consumer and a large mass, which reaches over almost the entire circuit board surface and also serves as a shield. High-quality power connectors ensure an almost loss-free
Power transmission. Ground loops were consistently avoided. With 2 parallel rows of slots and a total of 20 polarity-secure tub connectors, it is possible to supply 2 module rows with one board. The coded connector system (+5V, +12V,-12V, GND, GND) prevents short circuits caused by incorrect plugging and protects your modules from damage. 2 additional parallel plugs allow a direct connection to another board (power bus). The 3 LEDs on the left edge of the board (see fig. 1) are used to control the power supply (+12V, -12V, +5V). If the system is operating correctly, all 3 status LEDs must light up green. The Berlin board bp20 can be mounted in the housing in a stable and demand-oriented way. There are 16 possible mounting points available for this purpose.