This website uses cookies, which are necessary for the technical operation of the website and are always set. Other cookies, which increase the comfort when using this website, are used for direct advertising or to facilitate interaction with other websites and social networks, are only set with your consent.We currently only use technically necessary cookies of the shop system (shopware) and for the chat system LiveZilla installed locally on our web server.
4ms Passive Mult is a flexible two-channel multiple DIY kit
The Passive Mult is a two channel multiple. It can function as a dual one to three mult, or in a single channel/normalized one to six configuration. Since the device is passive it can also be used as a three to one, or six to one mixer!
This module requires no power, so all you have to do is build up and install it in your enclosure with the supplied 3mm screws.
Attention! The do-it-yourself kit includes all the parts necessary to build a Passive Mult. This is a beginner-level kit, but you need some prior experience and basic hand tools (small screwdriver, soldering iron, etc.). We unfortunately cannot assist with assembling/soldering the kit and take no responsibility if the kit does not work after self-assembly.
Note: the Passive Mult is only fully compatible with sliding nut cases. Other cases will either require a gap on one side of the Passive Mult, or require the rail mounting holes to be made larger.
Based in Portland (Oregon, US) Dan Green and Jeannot Quenson had a years experience already building guitar pedals. Since one input/output and tone and volume control felt a bit limiting, they applied their knowledge and passion to building a wide range of modules. Their collaboration with Matthias Puech (developer of the Clouds' Parasites alternative firmware) and Gary Hall (designer of the Lexicon PCM42) have proved to be very fruitful.
