This website uses cookies, which are necessary for the technical operation of the website and are always set. Other cookies, which increase the comfort when using this website, are used for direct advertising or to facilitate interaction with other websites and social networks, are only set with your consent.We currently only use technically necessary cookies of the shop system (shopware) and for the chat system LiveZilla installed locally on our web server.
Product information "Analogue Systems RS-70 Inverter/Preamp"
In the RS-70 module you will find an inverter with integrated slew limiter and also a pre-amp.
The Inverter should be described as a polarizer, to be exact, as the input signal can be blended from negative to positive with a level control. In minimum position of the knob the inverter creates an inverted signal with 10 times the amplitude of the input signal. In middle position the signal level is at zero. In maximum position you´ll get the positive signal with 10 times the amplitude of the input signal. Besides that you´ll find a slew limiter that smoothens the signal´s edges. Its speed is controlable from 0.1mS to 1S. The circuitry accepts signals with an amplitude of +/-10V and 20kHz frequency, though only frequencies up to 10khz can be output. there are two output jacks.
The pre-amplifier has two signal inputs: one for signals with low impedance and one for signals with high impedance. The gain control ranges from approximately -2dB in its fully anticlockwise position to +21dB in its fully clockwise position, depending upon the input used. Input signals with a level of +/-10V will be processed without problems, above those ranges clipping will occur and thus the module will distort which can be a desired effect. The output signal is present at two jacks.
HE:
3
TE:
12
Depth:
50
Power consumption +12V:
7
Power consumption -12V:
7
Related links to "Analogue Systems RS-70 Inverter/Preamp"
Starting almost in parallel with Doepfer, Bob Williams established back in 1998 his own modular system with fine circuits reminiscent of the British tradition initiated with EMS in the 1970s. Despite offering initially a different power connector and panel width standard (which left a 1,5HP gap), all modules bearing the "N" on their names are adapted to work seamlessly with most eurorack cases. Still, it is worth checking the depth of your case.
