After Later Audio – uT_U (B-Stock)

The uT_U by After Later Audio is an incredibly versatile clock and rhythm generator.

This device is B-stock so in used condition. It is in perfect technical condition and comes with cable, screws and without original packaging.

Very good and versatile rhythm and clock generator! The Temps Utile should not be viewed just as the little brother of the Ornament & Crime (uO_C). Rather: What the O_C is for CV generation and quantization, the Temps Utile does in terms of rhythm and clock generation: a full master clock. Trigger sequencer, Euclidean rhythm generator, Burst, and Random generator. And for those who want to go even deeper: A Linear Feedback Shift Register (LFSR) mode and logic operators are also integrated. Assignable in any combination to the six available outputs. This is more than enough to clock and drive even large systems!

We now offer the uT_U by After Later Audio. The heart of the uT_U is based on a Teensy 3.1/3.2 dev board and is therefore equipped with a 32bit ARM Cortex M4. Also, the further hardware is adapted to the requirements: There are six inputs and six outputs. Four of the inputs are designed as CV inputs with 12Bit accuracy in the range of +/-5V. The other two are trigger/gate inputs, which become active from a threshold value of 2.5V. Since uT_U is mainly used to generate rhythms, five of the outputs are digital gate outputs, which can "only" switch on...off or 10V...0V. The sixth output is continuous: LFOs, sequences, and arpeggios in the range of +/-5V (at 12Bit accuracy) are possible. Signals pass through the uT_U with a latency of 0.1ms. This is very good, especially because it is about timing-critical signals!

The firmware is open source and is being constantly improved. In the future, you can certainly count on more functions and above all: You certainly can also throw your own programming ideas into the ring. Off the shelf, the uT_U is already delivered with very powerful programs. Each channel/output can be set to run a different program. Via the main menu the following seven, implemented programs are quickly accessible:

• Trigger sequencer/sequence editor
• Clock divider/multiplier
• LFSR (Linear Feedback Shift Register)
• Random rhythms with an adjustable threshold value
• Euclidean rhythm generator
• logic operators for linking inputs and/or channels  (AND, OR, XOR, NAND, NOR, XNOR)
• Burst generator
• Exclusively for the 4th channel, which is linked to the continuous DAC output:
• random sequences, sequencer/arpeggiator, and a few other modes known from the Ornament and Crime.

LFSR? XNOR? Some of it sounds dizzying. Especially when you consider that up to six different programs can run that can also be linked to each other. But this is exactly the strength of the uT_U. Admittedly: Some things read like a mathematics seminar. But due to the quick operation, you can quickly switch through the programs and start with the simpler ones. Gradually and with an open ear, you can approach the huge potential of the T_U. It ranges from rather simple, continuous clock applications to polymetric-random-free-jazz. For sure: This module can groove! Six-dimensional…if you want it to!

This After Later Audio version comes with the Jakplugg PCB.